MR-JE-300A Bộ điều khiển động cơ Servo Mitsubishi 3 KW

Mã Sản Phẩm: : MR-JE-300A
Tên Sản Phẩm: : MR-JE-300A Bộ điều khiển động cơ Servo Mitsubishi 3 KW
Danh Mục: : Servo Driver
Thương Hiệu: : Servo Driver MR-JE
Giá: : Liên Hệ

Chi Tiết Sản Phẩm

MR-JE-300A Bộ điều khiển động cơ Servo Mitsubishi 3 KW

Bộ điều khiển động cơ Servo Mitsubishi dòng MR-JE-A
Điện áp hoạt động:
- 3 pha 220VAC
Công suất: 3KW
Phần mềm cấu hình: Mr Configurator 2-SW1DNC-MRC2-E
- Cáp Encoder kết nối Bộ điều khiển MR-JE với động cơ Servo Motor: Cáp Encoder MR-JE
- Cáp Nguồn kết nối Bộ điều khiển MR-JE với động cơ Servo Motor: Cáp nguồn MR-JE
- Cáp phanh kết nối Bộ điều khiển MR-JE với động cơ Servo Motor: Cáp phanh MR-JE

Thông số kỹ thuật:

Servo amplifier model MR-JE-		100A	200A	300A
Output	Rated voltage	3-phase 170 V AC
	Rated current [A]	6	11	11
Power supply input	Voltage/frequency (Note 1)	3-phase 200 V AC to 240 V AC, 50 Hz/60 Hz
	Rated current (Note 7) [A]	5	10.5	14
	Permissible voltage fluctuation	3-phase 170 V AC to 264 V AC
	Permissible frequency fluctuation	±5% maximum
Interface power supply		24 V DC ± 10% (required current capacity: 0.3 A)
Control method		Sine-wave PWM control/current control method
Tolerable regenerative power of the built-in regenerative resistor (Note 2, 3) [W]		20	100	100
Dynamic brake		Built-in (Note 4, 8)
Communication function		USB: Connect a personal computer (MR Configurator2 compatible) RS-422: Connect a controller (1 : n communication up to 32 axes) (Note 6)
Encoder output pulse		Compatible (A/B/Z-phase pulse)
Analog monitor		2 channels
Position control mode	Maximum input pulse frequency	4 Mpulses/s (when using differential receiver), 200 kpulses/s (when using open-collector)
	Positioning feedback pulse	Encoder resolution: 131072 pulses/rev
	Command pulse multiplying factor	Electronic gear A/B multiple, A: 1 to 16777215, B: 1 to 16777215, 1/10 < A/B < 4000
	Positioning complete width setting	0 pulse to ±65535 pulses (command pulse unit)
	Error excessive	±3 rotations
	Torque limit	Set by parameters or external analog input (0 V DC to +10 V DC/maximum torque)
Speed control mode	Speed control range	Analog speed command 1:2000, internal speed command 1:5000
	Analog speed command input	0 V DC to ±10 V DC/rated speed (Speed at 10 V is changeable with [Pr. PC12].)
	Speed fluctuation rate	±0.01% maximum (load fluctuation 0% to 100%), 0% (power fluctuation: ±10%) ±0.2% maximum (ambient temperature: 25 °C ± 10 °C) only when using analog speed command
	Torque limit	Set by parameters or external analog input (0 V DC to +10 V DC/maximum torque)
Torque control mode	Analog torque command input	0 V DC to ±8 V DC/maximum torque (input impedance: 10 kΩ to 12 kΩ)
	Speed limit	Set by parameters or external analog input (0 V DC to ± 10 V DC/rated speed)
Servo function		Advanced vibration suppression control II, adaptive filter II, robust filter, auto tuning, one-touch tuning, tough drive function, drive recorder function, machine diagnosis function, power monitoring function
Protective functions		Overcurrent shut-off, regenerative overvoltage shut-off, overload shut-off (electronic thermal), servo motor overheat protection, encoder error protection, regenerative error protection, undervoltage protection, instantaneous power failure protection, overspeed protection, error excessive protection
Compliance to standards		Refer to "Conformity with global standards and regulations" on p. 17 in this catalog.
Structure (IP rating)		Natural cooling, open (IP20)	Force cooling, open (IP20)
Close mounting		Possible (Note 5)
Environment	Ambient temperature	Operation: 0 °C to 55 °C (non-freezing), storage: -20 °C to 65 °C (non-freezing)
	Ambient humidity	Operation/Storage: 90 %RH maximum (non-condensing)
	Ambience	Indoors (no direct sunlight); no corrosive gas, inflammable gas, oil mist or dust
	Altitude	1000 m or less above sea level
	Vibration resistance	5.9 m/s2 at 10 Hz to 55 Hz (directions of X, Y and Z axes)
Mass [kg]		1.5	2.1	2.1

Kết hợp động cơ Servo Motor:

Servo amplifier	Servo motor
Servo amplifier	HF-KN series	HF-SN series
MR-JE-10A	HF-KN13J	-
MR-JE-20A	HF-KN23J	-
MR-JE-40A	HF-KN43J	-
MR-JE-70A	HF-KN73J	HF-SN52J
MR-JE-100A	-	HF-SN102J
MR-JE-200A	-	HF-SN152J, HF-SN202J
MR-JE-300A	-	HF-SN302J

Servo amplifier	Servo motor
Servo amplifier	HG-KN series	HG-SN series
MR-JE-10B/MR-JE-10A	HG-KN13J	-
MR-JE-20B/MR-JE-20A	HG-KN23J	-
MR-JE-40B/MR-JE-40A	HG-KN43J	-
MR-JE-70B/MR-JE-70A	HG-KN73J	HG-SN52J
MR-JE-100B/MR-JE-100A	-	HG-SN102J
MR-JE-200B/MR-JE-200A	-	HG-SN152J, HG-SN202J
MR-JE-300B/MR-JE-300A	-	HG-SN302J